100pcs 470 ohm Resistor 1/4w (0.25 Watt) ±1% Tolerance Metal Film Fixed Resistor, Multiple Values of Resistance Optional

I used these to rewire a guitar and they withstood a lot of bending without the terminals snapping. Like seriously a lot of crimping (it's a semi hollow with no back cavity, i.e. only has f-hole access). I'm not to sure how to rate component quality as far as audio superiority but it sounds pretty good and I have a low noise floor even with single coils and a tube amp running pretty hot. Mostly reviewing out of surprise of the build quality of the terminals. Great buy all around.

as shown ,quick delivery

Nothing to say

Needed them to replace bad parts on my vehicle instrument panel.Worked great!

They work as expected

This worked on my ls swapped 944, the tach in the 944 would not pick up the weak 5 volt signal from the ls pcm...installed this in line with the tach signal wire and the factory tach stated working..

Fortunately I did not really need 1 percent tolerance, because these average 2.5% low. Some of us have calibrated equipment, and exercise proper cross check procedures. These do not pass. Do not rely on the "1%" specification.

I replaced my car's dome light bulb with an LED, and because of the way the door switch works, there was still a little current going to it that would normally not be enough to power an incandescent bulb, but since the LED only takes a fraction of the current to power, it would stay on dimly even when the door was closed and it was supposed to be off. Well, I looked up what to do about it and found someone suggesting to stick in a resistor with the same specifications as this one, and viola, it worked! I have it a bit jury-rigged for now, with the leads off the resistor just wrapped around each bulb-holder prong (it's one of those "festoon" style bulbs). If I get the time I'll solder it in a little more nicely later on. The only problem I have now is that I literally only needed one, and now I have 99 left over because I thought I was only getting a 10 pack but it was 100! Haha

I used this resistor for the jeep 3.0L swirl valve delete/ bypass and works perfectly.

I measured the resistance on these with my multimeter, they are in fact 3.6k ohm as advertised.

I was hoping for a thicker metal and not so flimsy but they do not work just fine.

Shipping was fast and I got my item sooner than expected.Product also matched with the listing and description.Overall, services was excellent. Definitely recommend!

Cheap and good quality. And the 100 pieces is a nice bonus. I used these resistors in place of my car's side airbags in the seats to mimic the circuit and it worked great. No SRS dash light.