Sequential Turn Signal Motorcycle Blinkers LED Front Rear Flowing Indicators Daytime Running Light Universal Compatible with Harley Honda Kawasaki Suzuki Yamaha

While I knew what I was getting into before purchasing, I made a mistake and broke one, but ordered a second pair. Delivery both times were quite prompt. The look is quite well, they flow with a 2004 Suzuki Marauder quite well. Just got to have some DIY skills and installation isnt all that bad. The whites aren't super bright in the front, but they are noticeable while the blinkers do their job as ler normal, nobody pays attention to them anyhow. I have the rears as brake lights/blinkers and they work on que every time. If you have an older bike, you may run into the no blink or fast blinking due to your blinker relay being for traditional blinkers. As well, it would behoove you to purchase yet again, if your bike or atv have tradional blinkers to start with, the voltage regulators. They help tremendously with brightness. LED's don't require heat to turn on, just low power source. Which the tradional relay cannot muster quick enough, thus giving you the fore mentioned issue. Just make sure you do your studying before purchasing LED blinkers. Over all though the blinkers and brake/running lights are great for what they are. They are sleek and add a kind of future feel to the bike while still delivering the proper functionality. Hope this helps some of you.

I mistakenly purchased these lights to go on a 1986 Honda 250 street bike. They didn't fit. That's my fault though. Chuck it up to not doing enough research. Due to my affinity to building some of my own gas-powered 'toys' though, I bench-tested them and while they are small in size, they are bright in output. The overall appearance and quality is great too. I'll be holding onto these in anticipation of using them on one of my future builds.

Thank u

It was made like crap,what’s to like ?

Genial

Ok so i installed these on my 06 bandit and they dont all light up i only get one light for blinker what am i doing wrong

Don’t over tighten the nut all u need is loctite and some torque. Lights are awesome. Work well on my cb360 .

Bought these for the harder stem compared to kinstecks. They are noticeably less bright than those, tbd if they last longer or not.

The media could not be loaded.

Once installed, threading on bolt rips right out of the light, nut on other side can be tightened until the turn signal falls right off!