Creality Ender 3 Pro Enclosure,Ender 3 V2 Neo Protective Cover 3D Printer Housing for Ender 3 V3 SE&KE,Ender 3 S1/S1 Pro,Bambulab A1/A1 mini(AMS NOT Include)Constant Temperature Tent-18.9×23.6×28.3''

Very good enclosure, it makes the printer a lot less noisy, keeps heat trapped so the room isn’t hot, and good peace of mind in case of a fire/heat issue. A bit of a tight fit with the ender 3 v3 KE, the filament spool lightly drags the top of the enclosure but it hasn’t seemed to bind or cause any issues with prints! Only downside is you will have to relocate the nebula pad if using usb drive with the ender v3 KE. Other than that small gripe, I highly recommend this product.

I bought this for a Creality Ender 3 Pro. The Amazon listing indicated which size to order, but when I assembled it, it was a lot larger than I expected. I do have room for it though, so it's no problem and gives me room to get my arms into the tent to work on the printer when needed.Speaking of assembly, it's easy to assemble once you've done it once before, but expect it to take a half hour the first time. The one-page directions are helpful and are CORRECT, so don't assume the directions contain a mistake, like I did, and then have to reassemble the whole thing again. :) The X, Y and Z dimensions of the frame are all slightly different, and if you turn the frame on its side or rotate it 90 degrees, the fabric cover will not fit.In operation it's great. There are two large velcro panels for easy access, and a huge zippered front and top. I didn't test it for fire protection but it absolutely helps to keep in heat and keep out breezes and temperature fluctuations in the room.All in all I'm very glad to have this! Just keeping dust off my printer and filament is a nice plus.

The fabric is nice. The plastic frame connectors are flimsy. The cover fits very, very tightly over the frame and one of the plastic connectors snapped while I was getting it all fit together. I used some tape to make it work. Someday I’ll print my own connector. Overall it’s a nice enough product and gets the job done for less cost than building my own. It also minimizes the smell of the PLA I’ve used, as well as helps keep the printer warm in my cool basement.

I bought this for my Anycubic Kobra 2 Neo, and it fit great! Sadly not wide enough for the side mount spool, but it's easy enough to print a top mount alternative and make it fit 😉

Take your time with assembly, haste makes waste. Yes the instructions could DEFINITELY BE MORE CLEAR.

Although the description says it fits the Neptune 3 pro, it in fact does not.Although the printer fits inside the frame, the wires and display are tight against the fabric inside and if not centered front to back, the table would hit either the front or the back.Also, the power outlet hole is on the right side, the Neptune 3 Pro’s power cord comes off the left side (looking at the machine from the front). You can use the large pocket door on the left to run your power cord out but it’s not as nice of a seal.Over all, not happy with the purchase, had I not accidentally thrown away the packaging between opening it and assembling it, I would have returned this. Instead I’ll keep it to house something smaller should I get it but will need to order one with more room to ensure proper clearance for the Neptune Pro.

It helps out a lot by keeping the heat from the printer in there! Great quality and huge in size!

I like the enclosure but the spool on my Ender 3 V3 KE stuck about 2 inches above the top of the frame so it was unusable to me and I had to send it back and will purchase the next size up.